LIU Qing 1,2 , WANG Laicheng 1,2 , WANG Aiguo 3 , LIU Ying 3 , WU Hangzhe 1,2 , ZHANG Chunqiu 1,2 , LI Kun 4
  • 1. Tianjin Key Laboratory for Advanced Mechatronic System Design and Intelligent Control, Tianjin University of Technology, Tianjin 300384, P. R. China;
  • 2. National Demonstration Center for Experimental Mechanical and Electrical Engineering Education, Tianjin University of Technology, Tianjin 300384, P. R. China;
  • 3. Tianjin Academy of Traditional Chinese Medicine Affiliated Hospital, Tianjin 300120, P. R. China;
  • 4. Tianjin Key Laboratory of Film Electronic and Communication Device, Tianjin University of Technology, Tianjin 300384, P. R. China;
ZHANG Chunqiu, Email: zcqarticle@163.com; LI Kun, Email: likun_tjut@163.com
Lumbar intervertebral disc; High loading rate; Zhu-Wang-Tang constitutive equation; Strain rate dependent; Damage severity
10.7507/1001-5515.202602008
Export PDF Favorites Scan Get Citation

Abstract Full text Figures/Tables References Cited by

In daily life, the human body inevitably encounters accidents such as falls and slips. Sudden high-rate loading under such circumstances may lead to a certain form of annulus fibrosus injury or rupture, yet the underlying injury mechanism remains unclear. This study quantitatively analyzed the mechanical mechanisms of lumbar intervertebral disc injury under high-strain-rate loading, while considering the influence of the degree of damage. A total of 56 ovine lumbar intervertebral disc specimens were prepared and divided into four groups (healthy, mildly damaged, severely damaged, and herniated) to measure their stress–strain curves at different strain rates. The results show that under high strain-rate loading, the elastic modulus, peak stress, and yield stress vary slowly with strain rate, and the rate of change is much lower than that under quasi-static loading. The elastic modulus, peak stress, and yield stress of all specimens decrease significantly with increasing injury severity, while the peak stress and yield stress rise rapidly with increasing strain rate. Magnetic resonance imaging (MRI) showed that, after compressive loading until rupture, the nucleus pulposus area is notably reduced in severely injured and herniated specimens, and nucleus pulposus extrusion is observed in some samples. In summary, the Zhu-Wang-Tang (ZWT) constitutive model is employed to characterize the viscoelastic mechanical behavior of lumbar intervertebral discs under high strain-rate loading, and a damage factor is introduced to describe the damage evolution. The fitted curves from the constitutive model agree well with the experimental curves. The results reveal the damage evolution patterns and mechanical mechanisms of the lumbar intervertebral disc under the combined effects of high strain rates and pre-existing damage levels, providing theoretical guidance for the analysis of lumbar intervertebral disc injury risk under dynamic loads such as falls and slips.

Citation： LIU Qing, WANG Laicheng, WANG Aiguo, LIU Ying, WU Hangzhe, ZHANG Chunqiu, LI Kun. Combined effects of high loading rate and damage severity on the mechanical behavior of lumbar intervertebral disc injury and analysis of the underlying mechanisms. Journal of Biomedical Engineering, 2026, 43(5): 982-990, 1000. doi: 10.7507/1001-5515.202602008 Copy

Copyright ? the editorial department of Journal of Biomedical Engineering of West China Medical Publisher. All rights reserved

  • Previous Article

    Design and analysis of a serial ankle rehabilitation robot

  • Next Article

    End-to-end digital holographic phase reconstruction using an improved convolutional neural network